Problem invoking Texane GDB Server (St-util.exe)

Need help? Post your issues and bugs here. We will try to fix them.
FAQs

1 post | Page 1 of 1


tolakrow

Posts: 1
Joined: 01 Sep 2015 07:18

Problem invoking Texane GDB Server (St-util.exe)
Postby tolakrow » 01 Sep 2015 07:55

1) Below is the result I get when starting a debug session on an STM32F4 Discovery board.

2) I have trawled the IDE looking where one would edit the initialization commands - but to no avail. Also looked in some .conf and .xml files to see where the commands are stated

3) Invoking st-util.exe from a command prompt box gets a connection established with the Discovery board. The chip is identified, the target voltage of 2900mV is reported and the server listens on port 4242.

4) IDE is V2.20. St-link is V2.J24.S0, Windows 8.1 the development platform.

5) Hopeful of a simple resolve.

-------------------------------

Starting debugger: C:\Program Files (x86)\emIDE\St-Link\st-util.exe -nx -fullname -quiet -args M:/Dev/Controller/C02/Debug/C02.elf
done

[debug]st-util: unknown option -- x
[debug]st-util: unknown option -- f
[debug]st-util: unknown option -- u
[debug]st-util: unknown option -- l
[debug]st-util: unknown option -- l
[debug]st-util: unknown option -- a
[debug]st-util: unknown option -- e
[debug]st-util: unknown option -- q
[debug]st-util: unknown option -- u
[debug]st-util: unknown option -- i
[debug]st-util: unknown option -- e
[debug]st-util: unknown option -- t
[debug]st-util: unknown option -- a
[debug]st-util: unknown option -- r
[debug]st-util: unknown option -- g
[debug]stlink version 1627416985 unknown!

Debugger finished with status 1

Top


1 post | Page 1 of 1


Jump to:


Who is online

Users browsing this forum: No registered users and 1 guest